WHITNEY
BEAM PUNCH LINE ELECTRICAL
AND HYDRAULIC UNITS
Control
Voltage
110V
Power
Unit
10HP
220/440/3/60
Motor
Control
Magnetic
Starter
Conveyor
Drive
2HP,
SCR Motor
WHITNEY
BEAM PUNCH LINE CONVEYORS -
POWERED IN FEED and OUT FEED
Maximum
work piece length
up to 60’
Maximum
work piece weight
200 lbs/ft.
Conveyor speed
variable 80
ft/mi
BEAMS
Max
Min
(B)
LIGHT BEAMS:
31
lb - 16”x 5-1/2"
9
lb - 6” x 4”
(W)
WIDE FLANGE BEAMS:
200
lb - 33”x 15-3/4”
17
lb - 8” x 5-1/4”
(M) MISCELLANEOUS BEAMS:
30
lb - 10” x 5-3/4”
15
lb - 6" x 6”
(AS) AMERICAN STANDARD
BEAMS
120
lb - 24” x -7/8”
15
lb - 7”x35/8”
(C) AMERICAN STD
CHANNEL
50
lb - 15” x 3-3/8”
10
lb - 7” x 2-1/8”
(MC) MISCELLANEOUS CHANNEL
58
lb - 18” x 4”
12
lb - 6" x 2-1/2”
ANGLE
IRON
Max
Min
1
57
lb 8" x 8” x 1-1/8”
6
lb 3”x 3” x 5/16”
PLATE
Max
1
140
lb 36" x 1-18"
WHITNEY
BEAM PUNCH LINE USER BENEFITS:
Reduced man power -one man can do the
work of ten men
Reduced material handling - just 2
crane pick's required (load raw stock - remove finished
part)
Punching and layout capability both
are accomplished from the control console
Short or long material capability
Consistent material flow
Gives predictable quality and quantity
Makes estimating accurate
Produces holes economically
Allows switching to bolted connections
for large savings on fit-up welding and inspection
Beam line compensates for camber and
sweep - will accept mill tolerances
The WHITNEY BEAM
PUNCH LINE model 790-3 MBL features:
Two (2) 100 ton hydraulic FLANGE PRESSES that punch or lay-out both legs of the TOP-FLANGE in one pass. The flange gage is measured from either side of the web with allowance for the thickness of the web.
One (1) 100 ton hydraulic WEB-PRESS is used to either punch holes or lay them out in the web. The web holes are
gauged from the outside of the flange and standard AISC connections can be obtained with the 18” deep throat. The web-gage is measured with direct tape display The web-press carrier incorporates a counter balancing system that allows the press to float vertically to three positions, - die up, stripper down, and center for feeding.
Whitney Beam Punch Line Material Handling Included with
this Machine:
in feed conveyors powered 40’ OAL
Out feed conveyors powered 40’ OAL
Three (3) LIFT & CARRY Cross Transfers (PM) design)
One (1) Hydraulic Power unit 15 HP ISGPM (PMI design)
To receive your free
video and brochure on this amazing Beam Drill Line,
